Hi,
I have made a custom RTL8812AU board with FEM (including PA inside FEM), The issue is when i use the board with Ubuntu (Aircrack-Ng Driver) boards work fine but with OPENIPC Realtek drivers board get detected and start streaming but PAPE_5G pin of RTL8812AU does not produce any signal on both the channels, thus FEM's Power Amp does not get enable while transmitting video and im getting very little wireless range.
But with Ubuntu the PAPE_5G pin produces signal while TX and FEM's PA gets enable.
We have procured the new RTL8812AU chips and FEM is SKY85743-21. Please share if there is any chage or config enable required in RTL8812AU driver. I have used mutliple other OpenIPC compiled binaries as well but same issue.
Platfrom - SSC338Q
Wifi - RTL8812AU-CG
Hi,
I have made a custom RTL8812AU board with FEM (including PA inside FEM), The issue is when i use the board with Ubuntu (Aircrack-Ng Driver) boards work fine but with OPENIPC Realtek drivers board get detected and start streaming but PAPE_5G pin of RTL8812AU does not produce any signal on both the channels, thus FEM's Power Amp does not get enable while transmitting video and im getting very little wireless range.
But with Ubuntu the PAPE_5G pin produces signal while TX and FEM's PA gets enable.
We have procured the new RTL8812AU chips and FEM is SKY85743-21. Please share if there is any chage or config enable required in RTL8812AU driver. I have used mutliple other OpenIPC compiled binaries as well but same issue.
Platfrom - SSC338Q
Wifi - RTL8812AU-CG