App version
0.5.4
Flipper firmware
Momentum (mntm-dev)
Firmware version / commit
d3f89dfe
Hardware
PINGEQUA 2-in-1 RF Devboard (officially supported)
What happened?
When loading the "pingequa rf lab" I get "board not detected cc1101 fail (PN=00 V=00) NRF24 fail (AW=0F ST=0F)" If I disconnect board NRF24 fail (AW=00 ST=00) from =0F with board connected.
I have the Pingequa WiFi Devboard - ESP32-S2 that runs fine on my flipper.
I tried the official flipper firmware 1.4.3 and got same error when running Pingequa RF Lab.
I set NRF24 SPI to Extra 7.
Only plugged board in with flipper off.
Could someone please help?
Thanks G
Expected behavior
RF lab should detect board is attached and run.
Steps to reproduce
1 Plug in PINGEQUA 2-in-1 board
2. Launch Pingequa RF Lab
3. Error message board not detected cc1101 fail (PN=00 V=00) NRF24 fail (AW=0F ST=0F)
Error screen output (if any)
board not detected cc1101 fail (PN=00 V=00) NRF24 fail (AW=0F ST=0F)
Additional context
No response
App version
0.5.4
Flipper firmware
Momentum (mntm-dev)
Firmware version / commit
d3f89dfe
Hardware
PINGEQUA 2-in-1 RF Devboard (officially supported)
What happened?
When loading the "pingequa rf lab" I get "board not detected cc1101 fail (PN=00 V=00) NRF24 fail (AW=0F ST=0F)" If I disconnect board NRF24 fail (AW=00 ST=00) from =0F with board connected.
I have the Pingequa WiFi Devboard - ESP32-S2 that runs fine on my flipper.
I tried the official flipper firmware 1.4.3 and got same error when running Pingequa RF Lab.
I set NRF24 SPI to Extra 7.
Only plugged board in with flipper off.
Could someone please help?
Thanks G
Expected behavior
RF lab should detect board is attached and run.
Steps to reproduce
1 Plug in PINGEQUA 2-in-1 board
2. Launch Pingequa RF Lab
3. Error message board not detected cc1101 fail (PN=00 V=00) NRF24 fail (AW=0F ST=0F)
Error screen output (if any)
Additional context
No response